6/1/2023 0 Comments Linux show mac address by ip![]() Next, set the new MAC using command: sudo ip link set dev enp0s31f6 address XX:XX:XX:XX:XX:XX. First, turn off the network card using command: sudo ip link set dev enp0s31f6 down. Hi, If you have root privileges, you can use ifconfig -a, which will display the MAC address along with the IPs. The -A (aggressive scan) option forces nmap to use operating system detection, version detection, script scanning, and traceroute detection. I would recommend using Macchanger but if you don’t want to use it, there is another way to change the MAC address in Linux. We can use nmap more aggressively to try to winkle more information out of the device. The device with IP Address 192.168.4.11 had an unknown manufacturer and a lot of ports open. RELATED: How to Turn a Raspberry Pi into a Low-Power Network Storage Device Unknown Device With Many Open Ports It uses Samba so that I can connect to it from any computer on my network. This makes sense I use that particular Pi as a sort of mini-Network Attached Storage device (NAS). SMB is a means of sharing folders and files across a network. Samba is a free software implementation of Microsoft’s Server Message Block protocol (SMB). We’ve Lined Up The Suspects Let’s Make Them Talkĭevice 192.168.4.10 is a Raspberry Pi that has port 445 open, which is described as “microsoft-ds.” A quick bit of Internet searching reveals that port 445 is usually associated with Samba. To confirm your setting, you may prefer to execute ip link ls eth0 or ip addr ls eth0 instead of ifconfig eth0.
0 Comments
Leave a Reply. |